Project Zero G Forums Forum Index
Author Message
<  Swap Electrical  ~  2ga front cam sensor wire setup
tektic
PostPosted: Fri Jan 27, 2017 2:21 pm  Reply with quote
Knowlege Seeker


Joined: 05 Dec 2012
Posts: 19

I'd like to run a 2ga cam trigger and sensor in conjunction with a crank sensor. I'm using a 2g head and a 7 bolt wide block but a 1g harness. Does anyone have a schematic for this?
Back to top
View user's profile Send private message
Silverjoel
PostPosted: Sun Jan 29, 2017 2:15 am  Reply with quote
Knowlege Seeker


Joined: 22 Jan 2006
Posts: 23
Location: Alexandria, VA

This is kind of the opposite of what you want, but not really. It shows the wires in both the 1g CAS connector and the 2g CAS and crank sensor. Depending on what you are using for an ECU, you will need to invert the signal like in the pic. If you can flash the ECU to use the inverted signal you will not need to use this inverter. *Keep in mind that power would come from the 1g plug.





http://www.roadraceengineering.com/eclipsetech/justin/CASwiring95-96.gif
Back to top
View user's profile Send private message AIM Address
Display posts from previous:   
All times are GMT - 5 Hours

View next topic
View previous topic
Page 1 of 1
Project Zero G Forums Forum Index  ~  Swap Electrical

Post new topic   Reply to topic


 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum




Powered by phpBB and Ad Infinitum v1.06