Project Zero G Forums Forum Index
Author Message
<  Swap Mechanical  ~  Water Pump Pulley
PostPosted: Tue May 09, 2017 9:56 pm  Reply with quote
Too Much Time on His Hands

Joined: 22 Feb 2006
Posts: 619
Location: Las Vegas, NV

My car is finally up and running out terrorizing the streets. However, I took a peek today and noticed that my water pump pulley seems to be wobbling. The stock pulley sits on top of the power steering pump pulley to space it out and line up with the crank and alternator pulleys. I basically made a shim out of the power steering pulley, but must have done it wrong. I could have a wobble in the water pump pulley itself, but think I made the error.

What is everyone else using to space the pulley out? Do I even need to shim it? It's only about 1/16", but it might be enough to throw a belt at 7k rpm.

Do it in a Datsun!
1972 Datsun 510
7-bolt 4G63T, EVO 9 pistons and rods, Garrett GT3076R, "flipped" stock intake, Toyota R154, Z31 R200 w/ CVs
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
All times are GMT - 5 Hours

View next topic
View previous topic
Page 1 of 1
Project Zero G Forums Forum Index  ~  Swap Mechanical

Post new topic   Reply to topic

Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Powered by phpBB and Ad Infinitum v1.06